ETA Tonale User Manual

Page 30

– Steam ironing is not suitable for fabrics from synthetic and silk fibers (e.g.

acrylon,

nylon, polyamide, spandex, elastane or polyester). If you decide to iron such

materials, you have to set the thermostat control dial

A2 to the one dot symbol and press

the button for low steam generation

B2.

– Iron white and light materials on the right side; it is better to iron dark and embroidered

materials on the wrong side, it brings out the patterns.

– We recommend using soft textile permeable base materials for steam ironing.

– Make sure that the ironed fabric is tensed up properly so that steam does not leak to the

sides.

– For the ironing plate to remain smooth, protect it from direct contact with hard objects

(e.g.

zip fasteners, buttons, snap buttons, decorative objects). To put the iron aside,

use the resting plate of the boiler that is equipped with anti-slip pads and designed to

withstand very high temperatures.

Ironing without steaming (dry ironing)

Connect the power cord plug

B9 to the power supply, press button B1; you will hear

a sound signal (beep), the power supply connection indicator

B5 will turn on and the low

steam indicator in button

B2 will be lit intermittently (flashing). Place the iron in the resting

position (Fig. 5 A, B). Set the level according to the selected material on the thermostat

control dial

A2 (Fig. 2). When the set temperature is reached, the indicator A3 will switch

off.

WARNING

– During ironing the thermostat will cycle, which is accompanied by characteristic sound

(clicking). This is normal situation and does not form the reason for warranty claim

related to the appliance.

– The electronics of the appliance will evaluate ironing without steaming (dry ironing) as

if the appliance has not been manipulated with for a longer period of time and it will

automatically disconnect the appliance from the power supply after 10 minutes. To

activate the appliance again, press button

B1 or hold the steam control A4 down for 1

second anytime in the interval from 0 to 10 minutes from the last activation.

Recommendation

Control

A2 (Fig. 2) is marked with international symbols that recommend the optimum

ironing temperature and they are the same as marking on some types of laundry

and textiles (Fig. 3). When the temperature is increased from the cold state or if the

temperature is set from higher to lower, we recommend waiting for a while (see the

information on the display and listen for sound signalling) due to stabilization of the

ironing plate

A1 temperature.

Filling up the tank with water

Pull the water tank

C out (Fig. 4) and take off the cover of the water funnel C1. Pour clean

tap water into the tank up to the line (MAX 1.7 L) and close the funnel cap with

a snap. Insert the tank into the boiler in a reverse way, end-to-end. We recommend diluting

hard tap water with distilled water. You can obtain information on the water hardness from

the water supply network manager, or at a hygienic station. We recommend filling the iron

according to the following ratio when the water hardness is > 15 °N:

/ 58