ETA Verto User Manual
Page 19

II. EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER (Fig. 1)
A – vacuum cleaner
A1 – 0/I button
A4 – holder
A2 – light signaling
A5 – suspension mould
A3 – container lock button
A6 – power supply socket
B – dust container
B1 – filter
B2 – filter protector
C – holder (it applies to type ETA 2442)
D – brush adapter
E – slot adapter
F – rubber scraper
G – charged
III. PREPARATION AND USE OF THE VACUUM CLEANER
Remove all the packing material, take out the vacuum cleaner and the accessories.
Fastening of the holder to the wall (it applies to type ETA ETA2442)
Fasten the holder
C close enough to the electric socket using bonding material (Fig.3).
Make sure that there is no electric, telephone, plumbing fittings under the plaster at the
place of mounting the holder. You can also place the holder on a horizontal surface,
such as a table, etc. Then slide the vacuum cleaner
A to the holder together with the
accessories (
D, E, F).
Charging the battery
It is necessary to charge the accumulator at least 14 to 16 hours before first use. Plug the
adaptor
G into the el. mains. Slide the connector of the adaptor lightly into the socket A6
in the cleaner (for ETA0442) or use the charging holder
C, into which you may plug the
connector of the adaptor and put the cleaner in it (for ETA2442) pic. 2. The operation
of charging of the accumulator is indicated by the indicator
A2 (pic. 6). The accumulator
is usually fully charged after approx. 10 hrs and gives operation time for approx. 15 to 20
minutes (ETA0442 14–16 min; ETA2442 17–20 min). Turn the cleaner off before charging!
Using the vacuum cleaner
Disconnect the charger connector from the socket
A6 or remove the vacuum cleaner from
the holder. Choose suitable accessories (
D, E, F) according to the type of the cleaned
surface. Slide the selected adapter end–to–end to the hole in the dust container
B (Fig. 4).
You can turn the vacuum cleaner on and off by the switch
A1 (Fig. 6).
CAUTION
– Do not charge the battery for more than 24 hours!
– If you charge the battery for the first time or after long storage, about 60 % of its total
capacity is charged. After repeated discharge and repeated recharge the battery
is charged to 100 %.
– Let the charger cool down for at least
15 minutes between charging.
– After completing hard work or in hot environment, the battery may be too hot for
charging. Let the battery cool down before charging.
– The control light
A2 does not provide any information about how much the battery
is charged.
GB
19 / 34