ETA Verto - Manual (Page 18)

– When the battery is charged, the charger is hot which is a normal condition.
– Charge the battery at standard room temperature.
– Leaking of electrolyte from the battery is caused by overloading the vacuum cleaner
or by using the vacuum cleaner at extremely hot temperature. If you are splashed with
electrolyte, wash the affected place with water and soap and rinse it with lemon juice with
vinegar. In eye contamination, rinse the affected eye for a couple of minutes with clean
water and seek medical advice immediately.
– Do not through the battery into fire. There is a risk of explosion!
– Do not charge the battery if electrolyte is leaking from it.
– Do not expose the battery to temperatures exceeding 50 °C. This will prevent damage
of the battery.
– The appliance must be disconnected from the power adapter when removing the battery.
– Do not connect the contacts of the battery or the charger! If you do not use a battery,
keep it away from metal objects, such as paperclips, coins, keys, nails, screws or other
small metal objects that can cause short circuit of the battery connectors. Short circuit
of the battery connectors can cause burn or fire.
– Before you start using the vacuum cleaner, please check that all the blocking
mechanisms are in the right position.
– Never vacuum without a properly inserted filter protector and filters!
– Never use (switch on) the vacuum cleaner if it is placed in the holder and
it is being charged!
– The vacuum cleaner is not suitable for vacuuming substances that can harm the human
health.
– Do not vacuum sharp objects (e.g. glass, shatter), hot, flammable, explosive objects
(e.g. ash, hot cigarette butts, gasoline, thinners, aerosol vapours) or greases
(e.g. fats, oils). Vacuuming these objects may lead to damage of the filters or the
vacuum cleaner.
– When vacuuming some kinds of carpets, upholstery fabrics, etc., electrostatic discharge
may occur which is not dangerous for the user.
– Pores of the filter may be clogged when vacuum cleaning very fine dust (e.g. fine
sand, cement dust, plaster). Thus, air permeability will be reduced and the suction
performance will drop. In this case, the container has to be emptied and the filter cleaned.
– Do not insert fingers or other things to input and output vents of the appliance. If the
openings/elements for air flow are clogged (e.g. the accessories), turn the appliance
off and remove the clogging.
– If you need to use the extension cord, it has to be uncorrupted and it has to comply with
the valid safety standards.
– If the power cord of the battery is corrupted, it has to be replaced by the manufacturer, its
service technician or a similarly qualified person so as to prevent dangerous situations.
– Never use the appliance for any other purpose than for the intended purpose described
in these instructions for use!
– In order to ensure safety and proper function of the appliance, use only original spare
parts and accessories approved by the manufacturer.
– All text in other languages and pictures shown on the packaging, or the product itself, are
translated and explained at the end of this language mutation.
– The pictures are only illustrative, the supplied accessory and cleaner may differ.
– The manufacturer is not responsible for damage caused by improper use of the
appliance and the accessories and its guarantee for the appliance does not apply in
situations when the safety warnings above are not complied with. Failure to replace or
maintain all filters regularly according to the instructions in Chapter IV. and also using
non–original filters, the properties of which resulted in failure or damage of the vacuum
cleaner, is also understood to be improper use of the appliance.
GB
18 / 34