ETA Efektiv User Manual

Page 24

Vacuum cleaner

After finishing every „

wet“ vacuuming, rinse the waste tank (shower it) for sanitary reasons

in running water and let it dry. Treat the surface of the appliance with a soft and damp

cloth, do not use coarse and aggressive detergents!

Nozzles (big, small) for wet vacuuming

It is recommended to check the nozzle for possible impurities after every „

wet“ vacuuming.

If there are some impurities, remove them. Rinse the accessories (shower them) for

sanitary reasons in running water and let them dry.

Floor nozzle / brush / TURBO nozzle

It is recommended to check the collectors / brushes for possible impurities after every

vacuuming. If there are some impurities, remove them.

Micro-filter and HEPA filter

Check and if necessary, replace both micro-filters after about 10 vacuuming. You can buy

spare filters in the elektro shop chain. After finishing every „wet“ vacuuming, clean the

micro-filters:

- Micro-filter

A9: take it out by pulling (Fig. 13)

- HePA filter

A10: release it by turning it in the direction of the „

„ symbol and then

remove it by pulling (Fig. 14).

Clean the micro-filter and the HePA filter in running lukewarm water. e.g. using a cloth

or a soft brush and let them dry completely (Fig. 16). Re-assemble individual parts in the

opposite direction. You can speed up drying by assembling the vacuum cleaner and by

sucking clean air for several minutes. This will dry not only the waste tank, but also the

tubes and the hose.

VII. TROUBLESHOOTING

Problem

Cause

Solution

Motor won‘t start

Power supply not

Check the power cord, the plug and

connected

the socket

The button is not

Push on/off button

switched on

The suction

Open suction

Close the hole in the hose handle

performance is not

sufficient

dust container full

empty the container

Clogged micro-filters

Clean or replace the micro-filters

Nozzle, suction hose or

Remove the blocking objects

tube is clogged

The suction

Wet impurities container

empty the container

performance is

is full

insufficient safety float

activated