ETA Efektiv - Manual (Page 22)

Tubes
- You can connect the tube C3 with the hose handle C2 by slight pushing the handle to the
tube (Fig. 4).
- You can disconnect the tube by pulling the handle slightly out of the tube.
Floor nozzle, water vacuuming nozzle
- Connect and disconnect the accessories ( C1, C4) in the same way as the tube (Fig. 3).
Articulated brush, crevice nozzle and wet impurities nozzle
- Connect and disconnect the accessories ( C5, C6, C7) in the same way as the tube
(Fig. 3). You can slide the accessories onto one or both suction tubes or directly onto the
handle of the suction hose.
IV. USING VACUUM CLEANER - VACUUMING DRY MATERIALS
The floor nozzle C1 is designed to be used to clean carpets or smooth flooring (Fig. 6). If
the floor nozzle is fitted with a brush, pull it out by switching over the flap when vacuuming
hard floorings. You can use the crevice nozzle C6 for vacuuming places that are hard
to access (Fig. 7) or you can vacuum various pieces of furniture with the brush C5 (Fig.
8). Unwind the necessary length of the power cord A6 and plug it into an electric socket.
You can switch the vacuum cleaner on and off by pressing the button A2 marked with the
symbol „ “ (Fig. 9).
You can control the suction regulation by slight opening of the hose handle C2 (Fig. 10).
The minimum suction power is recommended for fine fabrics (e.g. curtains, drapes). The
maximum suction power is recommended for floor coverings (e.g. heavy-duty carpets).
When you have finished vacuuming, switch off the vacuum cleaner, then disconnect it from
the electric power and wind the power cord to the moulded jag on the vacuum cleaner and
secure it. The vacuum cleaner can be held by the handle A1 (Fig. 17) and carried over
obstacles (e.g. thresholds, steps).
Emptying the dust container
If you find out that the suction performance of the vacuum cleaner is reduced, make sure
that the dust container is not full and if necessary, empty it (see paragraph V. Finishing
Vacuuming)
VACUUMING WET MATERIALS OR WATER
- Used accessories: nozzle big ( C4), small (C7).
disassemble the vacuum cleaner according to the instructions above. Before setting on the
drive unit, make sure that micro-filters are properly set and secured. Hold the drive unit and
check movability of the float by the sound in intensive movement up and down. Assemble
the vacuum cleaner in the opposite direction.
Take out the floor nozzle from the suction tubes by pulling it. Put the nozzle C4 or C7 on
the suction tubes. Turn on the vacuum cleaner by the switch A2 (Fig. 9). When vacuuming
water from tanks where the level of water is higher and where the volume is bigger that
what the waste tank can take in ( max. 4 l), without a nozzle, for proper function of the
closing float it is necessary to have the suction A8 in the hose handle open (Fig. 10).
Make sure that you interrupt vacuuming in time and empty the container adequately
(Fig. 11). After filling the waste tank, the float will close the suction vent. This is signalled
by increased noise produced by the motor and also, the liquids are not vacuumed
any more.
22
GB