ETA Efektiv User Manual

Page 21

- The manufacturer is not responsible for damage caused by improper use of a detergent,

the appliance and its accessories and its guarantee for the appliance does not apply

in situations when the safety warnings above have not been complied with. Failure to

replace or maintain all filters regularly according to the instructions in Chapter

V., VI. and

also using non-original filters, the properties of which resulted in failure or damage of the

vacuum cleaner, is also understood to be improper use of the appliance.

II. EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER ETA – 0869 (Fig. 1).

A - MOTOR PART

A1 - handle

A6 - power cord

A2 - START/STOP button

A7 - accessories holder

A3 - locks

A8 - anti-flow safety float

A4 - moulded jag for cable winding

A9 - protective micro-filter

A5 - motor ventilation holes

A10 - HePA filter

B - COLLECTION CONTAINER (volume - 4 l wet impurities / 6 l dry impurities)

B1 - suction vent

B2 - travel wheels

C - ACCESSORIES

C1 - floor nozzle

C2 - suction hose with end piece and handle

C3 - suction tube

C4 - nozzle with rubber spattle (for wet surfaces)

C5 - brush

C6 - crevice nozzle

C7 - nozzle for vacuuming wet impurities and liquids

Note

You can buy the optional TURBO nozzle for all types of vacuum cleaners.

III. VACUUM CLEANER PREPARATION

Remove all the packing material, take out the vacuum cleaner and the accessories. If the

accessories are placed in a container inside the vacuum cleaner, take them out from the

container. disassemble the vacuum cleaner by delicate bending of both locks

A3 on the

sides of the vacuum cleaner and now you can take the motor part

A from the container B.

Assemble the vacuum cleaner by putting the motor part on the upper edge of the container

and by slight push on the handle, the locking projections will be secured, accompanied with

the characteristic sound effect (snapping).

Assemble the vacuum cleaner according to selected type of cleaning (dry or wet) and

select the respective accessories (Fig. 2a, 2b).

Hose

- Connect the hose

C2 to the vacuum cleaner by sliding the end piece to the suction vent

B1 and by turning the end piece clockwise to the maximum position (Fig. 5).

- Take out the hose by opposite movement.

For trouble-free operation of the vacuum cleaner, please use

tested micro-filters recommended by the producer.