ETA Efektiv - Manual (Page 23)

If the described situation happens, switch off the vacuum cleaner and pour the remaining
water in the hose to the waste tank by lifting the hose above the level of the vacuum
cleaner. After finishing „ wet“ vacuuming, the vacuum cleaner has to be left in operation for
about 30 seconds. This will remove the remaining liquid in the tubes and in the hose.
CAUTION
- Never vacuum dry, wet impurities or water without protective micro-filters on.
- For sanitary reasons we recommend emptying the container outside residential
premises.
- do not use any aggressive washing or cleaning agents or hot water to clean the HePA
filter and the micro-filter.
- Cleaning the filter will not restore its original colour, but it will restore its filtration
properties.
- The dust container is not resistant to cleaning in a dishwasher.
- The HePA filter and the micro-filters are not intended for cleaning in a dishwasher.
- Neglecting regular replacement of micro-filters can result in the vacuum cleaner failure!
- Make sure that the contact surfaces and sealing elements are functional.
- We recommend replacing the HePA filter 2x a year. Replace the protective filter if it
cannot be cleaned properly or if it is damaged. You can buy a spare HePA filter and a
micro-filter in the network of elektro shops.
- When crossing obstacles (e.g. thresholds, steps), switch off the vacuum cleaner first,
lift it while holding it with the handle as there is a risk of tilting over and damage of the
drive wheels. When carrying the vacuum cleaner we recommend switching off the
motor (Fig. 17).
- If the vacuum cleaner turns over during vacuuming, put the vacuum cleaner in the
standing position during operation and then switch off the motor. After a short time, the
motor can be switched on again.
V. FINISHING VACUUMING
After finishing vacuuming, turn off the vacuum cleaner by the switch A2 „ “. Unplug the
power cord from the socket, wind it on the moulded jag in the vacuum cleaner and secure
it. disassemble the vacuum cleaner by removing: the motor part (Fig. 12) and the end
piece of the suction hose (Fig. 5). Hold the waste tank with both hands and empty it
(Fig. 15). If you intend to keep on working, assemble the vacuum cleaner in the opposite
direction; if you do not intend to keep on working, clean the vacuum cleaner, see
paragraph ( IV. MAINTENANCE).
Storing accessories
Put the accessories ( C5, C6, C7) into the holder A7. The remaining accessories, the floor
nozzle, suction tubes and the hose can be disassembled or left assembled. When storing,
always set the floor nozzle to the carpet position (i.e. with the brush retracted); thus you will
prevent bending of the bristles.
VI. MAINTENANCE
Always store the vacuum cleaner at a dry place, far enough from heat sources
(e.g. fireplace, stove, heating element) and protect it against weather conditions
(e.g. rain, sunshine). Treat surface of the appliance with a soft and damp cloth, do not use
coarse and aggressive detergents! Store the appliance properly cleaned at a dry, dust-free
place out of reach of children and incapacitated people.
23
GB