ETA Mariner bez exteronu - Manual (Page 39)

Cleaner Sets
In order to ensure proper operation of the pump and accessories, it is recommended to
flush the set with 1 - 2 l of clean water after you finished the cleaning. After all water has
been emptied, leave the pump running for another 20 seconds in order to remove all
residues of water out of the system.
Wet Cleaning Nozzles (Large and Small)
After every “ wet” cleaning, check visually whether there is no debris stuck underneath the
nozzle transparent cover. Should that be the case, unscrew the 4 pieces of Philips screws
(fig. 44), remove the transparent cover (fig. 45), remove any dirt or debris and reassemble
the tool in the reverse order.
Floor Tools / TURBO Tool
After every vacuum cleaning check visually for any debris stuck on the collectors/brushes.
Should that be the case, remove the dirt or debris.
Window Washing Tools
Check regularly the nozzle and mesh strainer for cleanliness. In case of uneven or faulty
spraying action, unscrew the ring nut (Figure 38), remove the nozzle (Figure 39) and the
strainer and clean these parts (Figure 40). When reassembling the unit, be careful to
position the nozzle correctly ( the correct position being defined by the locking lugs).
Intake and Outlet Micro-filters
After about 10 cleaning actions, check both micro-filters and replace them if necessary.
You can purchase spare filters and micro-filters in the elektro store chain. After finishing
every “ wet” cleaning, clean the intake micro-filter:
Intake Micro-filter: Remove the cap by pulling (Figure 41), then remove the micro-filter
and wash it in tepid running water (Figure 42). Leave the micro-filter
dry and reassemble the unit in the reverse order.
Outlet Micro-filter: Remove the mesh by depressing the cap in its upper part and tilting
it (Figure 46) and remove the micro-filter. Position the new micro-filter
in the mesh. Place the projections of the mesh into the two openings
in the casing of the cleaner and close it by tilting. You will hear
a “click”.
CAUTION
- Never use any aggressive detergents or hot water to clean micro-filters.
- Cleaning the filter does not restore its original colour but its filtration properties.
- Please pay attention the contact surfaces and seals are functioning.
- Neglecting the replacement of micro-filters may lead to the failure of the cleaner!
Observe the direction of positioning the micro-filter in the cleaner.
39
GB