ETA Mariner bez exteronu - Manual (Page 36)

VII. CLEANING CARPETING, HARD AND SMOOTH FLOORING AND UPHOLSTERY
- Accessories used: intake hose with end-piece and handle ( E1), intake tubes (E2), wiper
( E3), large tool (E4), small tool (E5), cleaning set (E6), clamp rings
( E7), detergent fluid (E8), dirt flap (D).
before starting to wet clean your carpet (carpet flooring), it should be vacuum cleaned dry
first in order to remove solid dirt and dust and to straighten its fibres. Moreover, before
starting to wet clean carpets, it is advisable to test the effect of the detergent on a discreet
place on the carpet. Remove any small pieces of furniture off the carpet. The legs of other
furniture should be wrapped with a suitable membrane to prevent them from coming into
contact with the detergent and avoid any risk of staining. Start to clean the carpet on one
end and proceed towards the door, in order to avoid stepping on and dirtying the already
cleaned carpet surface. Use the detergent moderately and remember that the carpet
should never get wet through. After cleaning, do not walk on the carpet until it has dried
completely.
The cleaner preparation procedure is the same as that described in chapter VI. CLEANING
WET SURFACES OR WATER. Remove the cover A6 in the motor part (Figure 26). Fill the
detergent tank via its filler with the supplied and recommended non-foaming detergent in
the amount of 3 - 15 ml of detergent per 1 litre of water. Fill up the tank with tepid water
( no more than 40 °C and 4 l), (Figure 27). Following the above procedure in the reverse
order, fasten the filter cap back.
Using moderate force, push the feed line connector into the valve situated in the front of
the motor unit (Figure 23). Plug the control valve in its bar on the hose handle (Figure 28)
and attach the cleaner set line to the straight hose and tubes using the clamp rings (Figure
30). Click the nozzle in the nozzle holder guide on the large tool (Figure 29). The detergent
is fed by depressing the control valve lever on the hose handle (Figure 31).
Mode 1 - Moderately Dirty Carpets
Depress the MOTOR and PUMPA push-buttons (Figure 20), the pump pilot light A5 will
turn on. Place the large tool in one corner of the room on the carpet (carpet flooring)
and start feeding the detergent. Move the tool slowly along the cleaned surface in the
direction indicated by the arrow (Figure 32). The fluid injected in the carpet is immediately
collected together with any dirt. The flooring stays only damp. At the end of the cleaning
sweep, release the control valve lever/button, lift the tool and start a new sweep closely
overlapping the last one.
Mode 2 - Very Dirty Carpets
Switch the motor OFF while leaving the pump running. Depress the control valve lever/
button, move the tool slowly along the cleaned surface and cover the surface of about
1 by 1 meter of the carpet with the detergent. Let the detergent take effect for a few
minutes. The pump can be switched OFF after you have applied the detergent. After that
collect all the detergent mix as completely as you can so that the carpet is completely
dried. In doing so, move backwards. Repeat the above procedure until you have treated
the whole surface.
36
GB