ETA Mariner bez exteronu - Manual (Page 37)

Cleaning Smooth Flooring
before starting to wet clean the flooring, the floor should be vacuum cleaned dry first.
The cleaning procedure is the same as that described in chapter ( VII. Moderately dirty
carpets). Click the wiper blade onto the large tool (Figure 33). Start the cleaning on one
end of the surface and proceed towards the door so that to avoid stepping on the already
cleaned surface. Do not walk on the cleaned surface until it has dried up completely.
Cleaning Upholstery
before starting to wet clean upholstery, it should be vacuum cleaned dry first. The cleaning
procedure is the same as that described in chapter ( VII. Moderately dirty carpets).
Using moderate force, push the small tool (Figure 34) onto one or two suction tubes or the
hose handle directly. The nozzle is installed in the same way as on the large tool
(Figure 29).
VIII. FINISHING WORK
After you have finished cleaning with the cleaner, switch the cleaner OFF with the MOTOR
and PUMPA switches. Unplug the cord from the mains and wind it in the holder of the
cleaner (Figure 48). Dismantle the cleaner by removing: the motor unit (Figures 9, 10), the
detergent tank (Figure 11), the suction hose connector (Figure 17) and the detergent feed
line from the valve (Figure 23). Take hold of the tank with both hands and empty the tank
over the thin edge (Figure 35). If you are going to do some more work with the cleaner,
reassemble the cleaner by following the above procedure in the reverse order. If not, clean
the cleaner (see chapter XI. MAINTENANCE), let the cleaner dry and then reassemble
it. You can facilitate drying by assembling the cleaner and letting it suck clean air for a few
minutes. This will dry not only the waste water tank, but also the hose and tubes.
IX. CLEANING THE WINDOWS
- Accessories used: intake hose with end-piece and handle ( E1), intake tubes (E2),
cleaning set ( E6), clamp rings (E7), detergent fluid (E8), window
cleaning set ( E16), dirt flap (D).
The procedure to prepare the cleaner and accessories is the same as that outlined
in Chapter ( VII. Cleaning upholstery). Fill the detergent tank with the detergent
recommended and supplied with the cleaner accessories, using double the concentration
recommended for cleaning carpets and alike.
Remove the control valve from the hose handle (Figure 28). Remove the nut on the control
valve which holds down the line leading to the nozzle on the large tool and pull the line off
the control valve barb. Install the line leading from the window cleaning tool on the control
valve barb and hold down the line with the ring nut (Figure 36). Remount the control valve
(Figure 28) and install the window cleaning tool on the suction tubes.
Fix the detergent feed line on the suction tubes using the clamp rings (Figure 30).
Window Washing Procedure
- Depending on how far you have to reach to wash the window to be cleaned, install the
tool either on the hose handle directly or at the end of one or both the suction tubes.
- Spray the detergent/water mix all over the window in such a quantity that it stays on the
surface.
37
GB