ESI Rekord M - Manual (Page 9)

ESI Rekord M
9
Playback
To playback a file, you can select it using the R EWIND /L EFT and F ORWARD /R IGHT buttons. The
bottom status section of the LCD display displays the filename. You can only play files in the
currently selected folder.
To actually start playback, push the P LAY /P AUSE button. The time display will show the current
position in the file and a play icon will be displayed. While playing you can move between files
with the R
EWIND /L EFT and F ORWARD /R IGHT buttons
Also while playing you can change the volume with the two VOLUME buttons on the right side of
Rekord M. When changing the volume, a volume bar will be displayed in the status section at the
bottom of the LCD display.
Playback is done by default via the built-in speaker but can be done via headphone / line output as
well, once it has been connected.
If you want to play multiple files at once, you can use the Repeat function in the menu as described
in chapter 4.
Delete Files
In order to delete a file, you need to select it first. You can only access files in the currently selected
folder. Press and hold the F
OLDER /U P button (button no. 8 from diagram in chapter 2) and a list
with files will appear under the name of the current folder. Navigate up and down with the
F
OLDER /U P and M ENU /D OWN buttons then select the file to delete by pressing and holding the
FUNC button on the right side. Rekord M will then display Delete? and you can select Yes or No
using the R
EWIND /L EFT and F ORWARD /R IGHT buttons. After selecting Yes, push the P LAY /P AUSE
button to confirm. The red LED will flash to confirm.
Note that deleted files cannot be restored, so this is final.
Key Hold function
The key HOLD slider on the left side of Rekord M (no. 11 from diagram in chapter 2) allows you to
lock all button entries. This is good if you are using Rekord M and you want to avoid that
accidentally a button is pressed to start / end a recording or change a setting. To enable it, move the
slider up. To disable it, move it down again.
4. Menu Settings
To access the menu settings of Rekord M, you need to shortly push the M ENU /D OWN button (button
no. 17 from diagram in chapter 2). There are two menu sections, called Rec. Settings (everything
related to recording) and Func. Settings (all other general settings). The default after turning on
Rekord M is Rec. Settings.
Once you are inside the menu, you can navigate using the F OLDER /U P and M ENU /D OWN buttons to
go up and down inside the Rec. Settings or Func. Settings menus.