ESI uniK 04 - Manual (Page 7)

ESI uniK 04
7
1. TRS input (Left / Right) – these jacks accept TRS input connections, either balanced or
unbalanced. For balanced connections, a 3-conductor TRS plug is necessary. The TRS input is
wired like this:
INPUT SIGNAL TRS CONNECTIONS
+ Tip
- Ring
Shield Sleeve
Unbalanced wiring works with either a 2- or 3-conductor TRS connector. A 2-conductor TRS plug
(or sometimes also just called TS plug) automatically grounds the minus signal input, whereas a 3-
conductor TRS plug wired unbalanced provides the option of leaving the minus open or grounded.
We recommend that you ground the unused input.
2. vent port – uniK 04 is a vented box speaker system with a vent port on the rear panel. Make sure
you are not blocking the vent port (i.e. by putting the speaker too close to a wall) or the sound
colour will be changed.
3. speaker wire connection – use these connectors to connect the included speaker wire with the
second passive uniK 04 speaker.
4. power switch – when you push the power switch, uniK 04 will be turned on, and
–surprise– it will be turned off when you push the power switch again.
5. power port with ext. fuse – use this connector to plug in the detachable 3-circuit line cord that
connects to the power outlet. The connector contains a replaceable fuse (T1AL/250V).
Front Panel