ESI uniK 05 - Manual (Page 8)

ESI uniK 05
8
Rear Panel
1. XLR input – this connector accepts balanced XLR input connections (optimised for +4dBu).
XLR input is wired like this:
INPUT SIGNAL XLR CONNECTIONS
+ PIN 2
- PIN 3
Shield PIN 1
2. TS input – this jack accepts TS input connections, unbalanced (optimised for -10dBV). The TS
input is wired like this:
INPUT SIGNAL TRS CONNECTIONS
Signal Tip
Shield Sleeve
The TS input should not be used with balanced TRS signals. Although this is possible, the input
level will not be correct in that case. For balanced connection, please use a XLR cable whenever
possible.