ESI SW10K - Manual (Page 5)

5
SW10K Features
1. S UBWOOFER
Subwoofer unit is 10inch in diameter with mineral filled polypropylene cone with high
temperature voice coil and damped rubber surround. It is designed to deliver balanced
subwoofer response. Polypropylene is used to react against the input signal accurately and to
deliver even minimal input precisely minimizing distortion.
2. E NCLOSURE
Enclosure acts as important role as the other components. SW10K enclosure is designed to
endure impacts from inside under extreme conditions. It employs high-density special MDF and
unique interior reinforcement to provide more stable performance.
3. N ETWORK & P OWER A MPLIFIERS
Network & Power Amplifiers for SW10K are specially designed for its own subwoofer.
Network distributes subwoofer frequency properly to driver in order to reduce loss of sound and
distortion achieving natural balance of the sound.
In order to generate ultra crispy, powerful sound quality, there is special designed power
amplifier inside SW10K to drive Subwoofer driver by matching each parameter between
amplifier and driver. The power delivered to subwoofer driver at rated distortion is 100W.
Installation
1. P RECAUTIONS
Handling
Do not grab the speaker driver unit: SW10K is packaged in box fitted tight, so your attention is
required when taking speakers out of the box. To avoid the possible damage to the speaker
driver unit, hold both sides of the speaker to pull out of the box. The speaker driver unit should
not be touched to avoid the damage even after it is out of the box.
Recommend to use high quality balanced or unbalanced cable for input connection.
Turn off the power of SW10K and turn Volume Control of SW10K to minimum before
connection.