beautypg.com

Dodge 2010 Ram Truck User Manual

Page 206

background image

The two trip odometers show individual trip mileage. To
switch from odometer to trip odometers, press and
release the TRIP ODOMETER button.

To reset a trip odometer, display the desired trip odom-
eter to be reset then push and hold the button for
approximately two seconds until the display resets.

Vehicle Odometer Messages
When the appropriate conditions exist, the following
messages will display in the odometer:

ECO

. . . . . . . . . . . . . . . . . . . Fuel Saver Indicator Off

ECO-ON

. . . . . . . . . . . . . . . . Fuel Saver Indicator On

Lo tirE

. . . . . . . . . . . . . . . . . . . . . . Low Tire Pressure

noFUSE

. . . . . . . . . . . . . . . . . . . . . . . . . . Fuse Fault

CHAngE OIL

. . . . . . . . . . . . . . . Oil Change Required

LoWASH

. . . . . . . . . . . . . . . . . . . . Low Washer Fluid

NOTE:

There is also an engine hour function. This

indicates the total number of hours the engine has been

running. To display the engine hours on the base cluster,
perform the following: Place the ignition in RUN, but do
not start the engine. With the odometer value displayed,
hold the TRIP button down for a period of six seconds.
The odometer will change to trip value first, then it will
display the engine hour value. The engine hours will be
displayed for a period of 30 seconds until the ignition is
turned OFF or the engine is started.

If equipped, some of the above warnings will be dis-
played in the Electronic Vehicle Information Center
(EVIC) in the instrument cluster. Refer to ”Electronic
Vehicle Information Center (EVIC) — If Equipped” for
further information.

ECO / ECO-ON (Fuel Saver Indicator) — If Equipped
The ECO-ON indicator will illuminate when you are
driving in a fuel efficient manner and can be used to
modify driving habits in order to increase fuel economy.
The ECO display will toggle between ECO and ECO-ON

4

UNDERSTANDING YOUR INSTRUMENT PANEL

205