ELICA SEAGULL - Manual (Page 40)

en
40
Cleaning and care
Cleaning the surfaces
Danger due to electric shock! Discon-
nect the extractor hood from the power
supply by pulling the plug out of the
socket or by switching off the fuse.
When cleaning, make sure that no water
penetrates the device.
Regular cleaning of the surface saves
laborious removal of stubborn contami-
nation. Only use conventional deter-
gents or universal cleaning agents suit-
able for cleaning stainless steel/
aluminium. Never use abrasive cleaning
agents or steel wool. After cleaning the
hood, treat the stainless steel surfaces
with a stainless steel care product.
Painted surfaces should only be cleaned
using a mild detergent solution and a
very soft cloth. Only use a soft damp
cloth to clean the operating panel.
On hoods fitted with a panel below the
filter (edge extraction), grease deposits
occur at the edge of the panel. These
deposits occur for physical reasons and
are not due to a malfunction of the hood.
Please clean the panel underneath the
filter regularly to prevent the formation of
stubborn residues.
Cleaning and care instructions
When cleaning the grease filters, also
remove any grease deposits from the
accessible housing components. This
will prevent a fire hazard and maintain
an optimum range of functions. Use hot
soapy water or a mild window cleaning
agent to clean the hood. Do not scratch
off baked-on deposits. Soften them us-
ing a damp cloth. Do not use abrasive
agents or scouring pads.
Note: Do not use alcohol (spirits) on
plastic surfaces, as dull spots may re-
sult.
Caution: Ventilate the kitchen suffi-
ciently, no open flame.
Only clean the operating panel with a
soft damp cloth (mild detergent solu-
tion). Do not use stainless steel cleaners
for the sliding switch/pressure switch.
Stainless steel surfaces:
Use a mild and non-abrasive stainless
steel cleaning agent. Do not clean
stainless steel surfaces with abrasive
scouring pads or with cleaning agents
containing sand, soda, acid or chloride!
Clean in direction of polish only.
We recommend our stainless steel
cleaner no. 461731. See the enclosed
service booklet for the order address.
Aluminium, varnished and plastic
surfaces:
Use a soft microfibre cloth. Do not use
dry cloths. Use a mild window-cleaning
agent. Do not use aggressive cleaning
agents or agents containing acid or lye!
Do not use scouring agents.
Operating Instructions
Press T2 3x = Fan setting 3
L1 dark blue LED illuminates.
Press T2 4x = Fan off
L1 white LED illuminates.
When the hood is retracted:
Press T2 1x = Fan setting 2
L1 cyan LED illuminates.
Press T2 2x = Fan setting 3
L1 dark blue LED illuminates.
Press T2 3x = Fan off
L1 white LED illuminates.
If the hood stops moving because of resis-
tance while being extended or retracted,
the red LED L1 will come on. In this event,
switch the hood’s power off for 10 s.
Lighting T3
The lighting can be switched on by press-
ing T3.