Echo Bear Cat 75111 - Manual (Page 11)

Page 5 Bear Vac Pro Operator’s Manual
Assembly
ASSEMBLY INSTRUCTIONS (ALL MODELS)
WARNING
To prevent personal injury or prop-
erty damage: Shut off engine, dis-
connect spark plug wire, and make
sure that all moving parts have come
to a complete stop, before servic-
ing, adjusting or repairing.
The Bear Vac Pro is shipped with the
handlebar not attached to the machine.
1. Thread the two tie rods into the pivot
pins located on the bucket crank
weldment. Make sure the rods are
threaded evenly -- they will adjust
how high the bucket top weldment
lifts.
2. Align the tie rod, handlebar clamp,
and handlebar with the bolt holes
called out on Fig. #3. Note: The bot-
tom hole used will determine handle-
bar height.
5/16 X 2"
BOLT
HANDLE BAR
CLAMP
TIE ROD
5/16 FLAT
WASHER
5/16 NUT
NYLOCK
3. Insert (4) 5/16” x 2” bolts through tie
rod, handlebar clamp, and Bear Vac
Pro frame.
4. Place washer and locknut onto ends
of bolts.
5. Check lift of bucket top weldment,
and handlebar height. Adjust as
necessary.
6. Tighten bolts to proper torque.
Fig. #3