Echo Bear Cat 75360 2002 - Manual (Page 16)

Page 10 Bear Vac Operator’s Manual
ATTACH TY-RAP
CLAMPS (QTY. 6) AFTER
DESIRED HANDLEBAR
HEIGHT IS ACHEIVED
The handlebars are shipped in
the lowest position. If desired
the handlebars can adjusted to
four different positions.
NOTE
5/16" X 1-3/4"
CARRIAGE BOLT
HANDLEBARS
ADJUSTMENT
HOLES
5/16" FLAT
WASHER
5/16" NYLOCK
LOCKNUT
Operation
The handlebars of the Bear Vac can
be mounted in four different positions.
The handlebar is shipped in its lowest
position. If the handlebar needs to be
raised, follow the instructions below.
Adjusting the handlebars:
1. Loosen the 5/16” bolts holding the
lower handlebar onto the Bear Vac.
2. Remove the handlebar assembly
from the frame of the Bear Vac.
3. Move the handlebar to the desired
position on the frame.
4. Reconnect the handlebar to the
frame using the 5/16” hardware.
ADJUSTING THE HANDLEBAR HEIGHT
Fig. #7, Handlebar Adjustment