Echo Bear Cat 75360 2002 - Manual (Page 11)

Page 5 Bear Vac Operator’s Manual
Assembly
ASSEMBLY INSTRUCTIONS (ALL MODELS)
WARNING
To prevent personal injury or prop-
erty damage: Shut off engine, dis-
connect spark plug wire, and make
sure that all moving parts have come
to a complete stop, before servic-
ing, adjusting or repairing.
The Bear Vac is shipped with the up-
per handlebar draped over the front of
the machine.
Installing the handlebar:
1. Pick up the front handlebar and move
it to the rear of the machine.
2. Remove the 7/8” shipping caps on
the handlebar and discard.
3. Mount the upper handlebar to the
lower handlebar using the 5/16”
hardware provided in the owners kit.
4. Tighten bolts to proper torque.
5. Using ty-raps from the owners kit
secure the control cables to the ma-
chine.
Installing the bag:
1. Attach the the Bear Vac bag to
thebag handle/deflector.
2. Secure the bad to the bag handle/
deflector to the bag with the bag’s
strap.
3. Place the loops of the Bear Vac bag
into the bag hanger brackets.
4. Lift the exhaust door.
5. Attach the bag handle/deflector to
the fan housing of the Bear Vac.
5/16" X 1-3/4"
CARRIAGE BOLT
5/16" FLAT
WASHER
5/16" NYLOCK
LOCKNUT
NOTE: FOR SHIPPPING PURPOSES
ONLY, CAP CAN BE DISCARDED.
BAG HANDLE / DEFLECTOR
BEARVAC BAG
TY-RAP
CLAMP
BAG HANGER BRACKETS
RAISE EXHAUST DOOR
O ATTACH BAG HANDLE
/ DEFLECTOR
Fig. #2, Assembly instructions