Echo Bear Cat 70520 User Manual

Page 10

E C T I O N

engine)Turn knob clockwise for full throttle opera-
tion. Turn knob counter clockwise for idle on warm
up. Turn knob all the way down to shut engine off.
(14 hp engine) Pull lever up for full throttle opera-
tion. Push lever down for idle on warm up. Push
lever all the down to shut engine off. Refer to
engine owners manual for further engine operating
instructions.

2. Engine Choke. Use when starting cold engine. Pull

to on position when starting. Push lever to of
position when engine is running. Refer to engine
owners manual for further operating instructions.

3. Key Switch. (Not Shown) located above recoild

starter on engine case. Activate starter switch,
release switxh as soon as the engine is running. Do
not crank starter for more than 10 seconds or
damage may result.

4. Engine Fuel Tank. Use unleaded fuel only.

DONOT MIX OIL AND GASOLINE.

5. Trailer Hitch. Always use 2" ball and hook safety

chains to towing vehicle.

6. Jack Stand. Always have up and clear from the

ground when moving the unit. When the in use,
be sure jack stand is down and locked in position
with the snap pin.

7. Foot Pedal. Used to engage rotor drive belt.

PTO Models

1. 3 pt. Hitch Connections. Mount Chipper/Shred-

der to tractor. Connect direct for categorys 0 & 1. A
bushing kit must be installed on 3 pt. connections
for category 2 hitches.

2. PTO Shaft. Connects tractor PTO to Chipper/

Shredder Drive Shaft. Avoid angle greater than 20

up or down when unit is in use.

3. Leg Stands. Adjustable to allow proper driveshaft

angle. Don not move machine unless the legs clear
the ground.

4. Jackshaft. Used for correct belt tension adjustment.

Common Parts

A. Shredder Hopper. Material to be shredded are fed

through the hopper to the shredding knives.

B. Chipper Chute. Material to be chipped are fed

through the chipper chute to the chipper blades.

C. Drive Belt Shield. Never remove shield while

the unit is running.

D. Rotor Access Cover. Used to remove chipper blades

and service rotor assembly.

This manual is related to the following products:

71014