Echo Bear Cat SC2206 - Manual (Page 10)

2.75 INCH CHIPPER/SHREDDER 6
SAFETY
Check the oil level and if needed fill the engine crankcase
with the type and amount of oil specified in the engine
owners manual.
2.8 cHEcK/Add moToR oIL To ENGINE
2.7 FILL THE TANK 2.6 ATTAcH HoppER To cHIppER bodY
bolt the hopper panels to the chipper body and assemble
the hopper in the order shown below using 1/2" carriage
bolts and serrated flange nuts. The angled side panels
should be bolted on top of the rectangular panels. thread
the carriage bolts from the inside of the machine through
the chipper body and hopper. secure them on the outside
of the chipper with flange nuts.
WARNING
gasoline and diesel fuels are highly
flammable and their vapors are explosive. To
prevent personal injury or property damage:
store fuel only in approved containers, in
well ventilated, unoccupied buildings, away
from sparks or flames. A container with a capacity of 2
gallons or less with a pouring spout is recommended.
Do not fill the fuel tank while the engine is hot or running,
since spilled fuel could ignite if it comes in contact with
hot parts or sparks from ignition. Do not start the engine
near spilled fuel. never use fuel as a cleaning agent.
Do not Mix oil WitH FuEl.
use only those types of fuels that are recommended in
your engine owner’s manual.
to add fuel:
stop engine, wait for all parts to stop moving and 1.
disconnect spark plug wire. remove key from key
switch. allow the engine and muffler to cool for at least
three minutes.
Clean area around fuel fill cap and remove cap.
2.
using a clean funnel, fill fuel tank to 1/2” below bottom 3.
of filler neck to provide space for any fuel expansion.
install fuel fill cap securely and wipe up any spilled
gasoline.
1
2
3
4
FLAP
2.4 ATTAcH FLAp
Attach the rubber flap to the angled hopper side with three
(3) 3/4" hex bolts, fender washers and nylock nuts.
MANUAL HOLDER
2.5 ATTAcH mANuAL HoLdER
attach manual holder to the hopper panel with the handle using
three (3) 3/4" carriage bolts, nylock nuts and flat washers.