Replacing the throttle cable – DR Power 5.00 HP Power Wagon User Manual

Page 29

DR POWERWAGON 5.0 Safety & Operating Instructions

Figure 26

Figure 27

Replacing the Throttle Cable

Note:

The Throttle Cable is set at the factory and generally no service is required. The

cable is supplied as a complete assembly with the handle already attached.
(Figure 27) However, when replacing the throttle cable it is important to follow
these steps:

Tools Needed:

1/4" socket

Screwdriver

1. Loosen the screw on the

throttle cable clamp with
the screwdriver so the
throttle cable can slide
below it. It is not
necessary to remove the
clamp. (Figure 26)

2. Remove the "Z"-bend end of the cable from the throttle plate. (Figure 26)
3. Remove the two screws holding the throttle assembly to the control panel with the

1/4" socket or screwdriver. (Figure 28)

4. Tilt and slide the throttle assembly down through the slot in the control panel.

(Figure 28)

WARNING!

Before performing any maintenance procedure, stop the

engine, set the parking brake and disconnect the spark plug wire.

Throttle

Throttle Plate

Throttle Cable Clamp

Throttle Cable

"Z" bend

Figure 28

Throttle Assy

Screws

Slot