DR Power Sprint (2000 - 2004) - Manual (Page 27)

DR ® TRIMMER/MOWER ™ Safety & Operating Instructions 21
To Adjust the PTA
™
Lever
WARNING! Before performing any maintenance procedure, the engine should be stopped
and the spark plug wire disconnected.
It should be easy to engage the PTA ™ Feature. If you've moved the handlebar up or down the
PTA ™ lever may need to be adjusted.
1. Loosen the knob on the PTA ™ lever
(Figure 32).
2. Move the assembly up the handlebar
to tighten the cable, or down the
handlebar to loosen it. There should
be just a little slack in the cable when
the PTA is properly adjusted.
To Remove the Side
Shield
Tools Needed: • 7/16" wrench or socket
• 5/32" Allen wrench
WARNING! Before performing any maintenance procedure, the engine should be stopped
and the spark plug wire disconnected.
You should never operate the Trimmer without the side shield in place. If the side shield
becomes damaged, replace it immediately.
1. Remove the six mounting bolts and discard the old shield.
2. Mount the new shield, insert the bolts and tighten.
To Remove the Wheels
Tool Needed: • adjustable wrench
WARNING! Before performing any
maintenance procedure, the engine
should be stopped and the spark plug
wire disconnected.
1. Loosen the set screw and remove the
retaining ring (Figure 33).
2. Slide the wheel off the axle.
Figure 32
Figure 33