DR Power Self-Propelled Pro-XL Self-Propelled 8.26fpt Subaru User Manual

Page 18

TRIMMER/MOWER

Always make sure you remove the screwdriver from the head assembly when
finished. Failure to remove the screwdriver could cause injury when the head
assembly is engaged.

4. Looking down at the top of the Frame, turn the Mow-Ball

clockwise until it unscrews completely from the Bearing Housing.

Note: If the Mow-Ball

continues to turn, but does not come off, check to be sure that you locked the Screwdriver into the shaft.

If the Mow-Ball will not turn by hand a 9/16" Socket can be used on the Bolt (inside the bottom of the Mow-Ball) to loosen it.

You may need to clean grass or debris out of the recess first.

5. Slide the Line Plates off the Shaft.

6. Place the Spacer and Anti Wrap Canister (with the lip facing up) onto the

Shaft (Figure 24).

7. Align the flats at the center of the Plates with the flat on the shaft and slide

the Line Plates onto the Shaft. Ensure they are facing top side up as shown.

8. Place the head of the Mow-Ball

Bolt so it is sitting in the hex cavity at the

bottom of the Mow-Ball

9. Looking down at the top of the Frame, hold the Bolt Head in place with your

finger and turn the Mow-Ball

counterclockwise to start the Bolt into the

Shaft.

10. Tighten the assembly securely by turning the Mow-Ball

counterclockwise

when looking down on the top of the Frame.

11. Remove the Screwdriver.

Note: When finished there should be no gaps between any of the components.

Figure 24

Spacer

Line Plates

Anti Wrap
Canister

Mow-Ball

Bolt

Improper installation can cause damage to the trimmer bearings. Follow
these directions carefully to protect your machine from damage. Reassemble
the components in the order shown in figure 24.