Digital Alert Systems MultiPlayer - Manual (Page 13)

Digital Alert Systems
MultiPlayer Quick Start Guide
Revision 4.0 Page 13 of 13
8. Select any of the MultiPlayer GPI’s or GPO’s you wish to assign to this station holding the SHIFT
key or Control key (Command key for Mac users) for multiple selections.
Refer to the MultiPlayer GPI’s & GPO’s section of this document for more on ports
9. Click .Submit Selection Settings to save the station settings.
10. Repeat Steps 3-4 thru 3- 9 for each station.
Step 4 – Configuring the MultiPlayer GPI’s and GPO’s
1. Log in to the DASDEC
2. Go to Setup > GPIO > MultiPlayer GPIO
3. Using the pull down selections to define the action for each input or output.
SELECTIONS ARE IMMEDIATE
Figure 15 MultiPlayer GPI and GPO configuration page. Selections are immediate.
4. If you haven’t assigned the MultiPlayer GPI’s or GPO’s to a station you may want to return to
STEP 3 -7 and complete the station action table assignments.
Use pull-down to select
desired action
Selections are applied
immediately
Repeat on each port as
needed