Digi-Star RF DataLink Operators Manual - Manual (Page 14)

RF DataLink
8
Loads Made by Bunk Reader
Loads Made by Bunk Reader option allows the bunk reader software to create a specific
load to be built, then Datalink sends out the load information to the correct mixer/delivery
truck, one at a time.
Stationary List, Truck Loads
This option is used with a stationary mixer/batch box. This option sends out the recipe list to
the mixer/batch box. The operator at the mixer/batch box selects a recipe to build. When
the recipe is built, Datalink will evaluate the type/size of the recipe and then send out the
correct load of pens to a delivery truck.
Bunk Reader All Mixers
This option is like Loads Made by Bunk Reader. This option will send out all the loads at
one time to specific or all mixers. This option cannot be used with a stationary
mixer/batch box.
Auto Start Processing
This option allows the Datalink software enter the Processing screen immediately. This
option is useful when Datalink is set-up in the startup menu of Windows and incase of a
power outage.
Verify Ingredient Checksum
This option double checks all the data being sent from the scale indicator to Datalink. This
option is normally not selected. It is only selected if the Datalink program is experiencing
errors in the data being collected by the 3
rd
party bunk reader software.
Weigh Units
This selection sets the weigh units of the RF Datalink to either pounds or kilograms. Be
sure that the EZ indicator is set to the same weigh units.
Archive Data
This option allows you to have Datalink store all the pen feeding data into an backup
archive. This options is normally set to 14 day.
Defaults - File Directories
RF Datalink shares files with other software. As such, each program must know where to
send and where to look for these files.