Diamondback Fitness 510Ub - Manual (Page 12)

12
27. Position the handlebar assembly (B) in front of the
clamp near the top of the console mast (C).
28. Install the upper handlebar clamp fixing assembly
by loosely treading the fixing bolt (I‐4) through the
lock washer (I‐3), flat washer (I‐2) and clamp face
(I‐1) and into the upper hole of the console mast
(C).
29. Thread the T‐handle adjuster (I‐6) through the
spacer (I‐5), lock washer (I‐3) and flat (I‐2) washer
and into the console mast (C). Tighten the fixing
bolt (I‐4) and T‐handle adjuster (I‐6) evenly and
firmly, positioning the handlebar to the desired
position. The upper and lower gaps between the
console mast clamp and the clamp should be equal.
30. Snap the pulse wire grommet (B‐6) onto the pulse
wire (B‐2) as shown in the bubble to the left.
Thread the heart rate wire connector (B‐2) through
the hole on the right‐hand side of the console mast
(C) and upward, out through the opening at the
top. Fit the pulse wire grommet into the hole in the
right side of the console mast.
31. Bring the upper and lower handlebar pivot covers
(C‐9 & C‐10) together over the handlebar pivot and
install the two (2) Phillips screws (I‐10) through the
bottom cover and into the upper cover.
32. Install the four (4) screws (I‐11) through covers C‐9
& C‐10 and into the console mast.
33. Place the water bottle (C‐5) in the cage located on
the console mast.