Diamond Amplification MAC-2 - Manual (Page 15)

Now, press the buttons to select the function or functions that require
momentary switching. Make sure that only the momentary functions
are lit up and all others are not lit.
Once you’ve done th e MAC-2 will flash
its LEDs, then return to normal operating mode. The functions you
n the group, all of
the other switches
a ti
swi
is
To
1. Remove the power supply from the MAC-2
on 1 button until the LEDs flash
cluded.
nce you’ve done this, press the Write button. The MAC-2 will flash
its LEDs, then return to normal operating mode. The selected functions
will now act as a group.
is, press the Write button. Th
selected will now use momentary switching.
Grouping Functions
Using the Group setting, you can limit a group of switches to have only
one switch on at a time – if you turn on one switch i
in the group turn off. This is es
ree or more channels – only one ch
me, so putting them in a group will insure that
tch
on at a time.
pecially useful for
annel may be on at
only one channel
p a group:
amplifiers with th
set u
2. Hold down the Function 4 button and plug in the MAC-2’s
power supply
3. Keep holding the Functi
Now, press the buttons to select the functions that should be grouped
together. Any functions that are lit up will be in the group, and the ones
that are not lit will be ex
O
10