Diamond Amplification MAC-2 - Manual (Page 14)

MIDI channel, press the Write button. The
MAC-2 will flash its LEDs, then return to normal operating mode with
the new settings
whe
thes
e
C-2’s
power supply
tons to select the function or functions that are
inverted. Make sure that only the inverted functions are lit up and all
ess the Write button. The MAC-2 will flash
its LEDs, then return to normal operating mode. The inverted functions
should now w
can c
swi
n
C-2’s
power supply
Once you’ve chosen your
in effect.
Setting Inverted Functions
On certain amplifiers, a switching function is inverted. For example:
your amp has footswitchable reverb. But, when you control it from the
MAC-2, reverb is on when its function LED is not li
n its function LED is lit. If you find that this is
e st ps:
t and reverb is off
happening, follow
Remove the pow 1. er supply from the MAC-2
2. Hold down the Function 2 button and plug in the MA
3. Keep holding the Function 1 button until the LEDs flash
Now, press the but
others are not lit.
Once you’ve done this, pr
ork normally.
Setting Momentary Functions
A small number of amplifiers require momentary switching, where the
switch is turned on and then quickly turned off once ag
ac ommodate this. Follow the steps to en
tchi g:
ain. The MAC-2
able momentary
Remove the pow 1. er supply from the MAC-2
2. Hold down the Function 3 button and plug in the MA
3. Keep holding the Function 1 button until the LEDs flash
9