Chapter 3 – DFI HD330-Q87 User Manual

Page 35

www.dfi .com

Chapter 3 BIOS Setup

Chapter 3

Software Feature Mask Confi guration

RAID OROM/RST driver will refer to the SWFM configuration in order to enable or dis-

able the features of the storage device.

Enable or disable
RAID0 feature.

RAID0

RAID1
RAID10
RAID5
Intel Rapid Recovery Technology
OROM UI and BANNER
Smart Response Technology
OROM UI Delay

Advanced

[Enabled]

[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[2 Seconds]



Select Screen



Select Item

Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous

Values

F3: Optimized

Defaults

F4: Save & Reset
ESC: Exit

RAIO 0/1/5/10

Enables or disables the RAID feature.

Intel Rapid Recovery Technology

Enables or disables the Intel Rapid Recovery Technology.

OROM UI and BANNER

When enabled, then the OROM UI is shown. When disabled, no OROM banner or infor-

mation will be displayed if all disks and RAID volumes are Normal.

Smart Response Technology

Enables or disables the Smart Response Technology.

OROM UI Dealy

When enabled, it indicates the delay of the OROM UI Splash Screen in a normal

status.

PCH-FW Configuration

This section is used to configure the parameters of Management Engine Technology.

ME FW Version
ME Firmware Mode
ME Firmware Type
ME Firmware SKU



Firmware Update Confi guration

Advanced

9.0.10.1372
Normal Mode
Full Sku Firmware
5MB

Confi gure Management
Engine Technology
Parameters

Firmware Update Configuration

Enables or disables the function of Me FW Image Re-Flash.

Me FW Image Re-Flash

Advanced

[Disabled]

Enable/Disable Me FW
Image Re-Flash function.



Select Screen



Select Item

Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous

Values

F3: Optimized

Defaults

F4: Save and Reset
ESC: Exit



Select Screen



Select Item

Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous

Values

F3: Optimized

Defaults

F4: Save and Reset
ESC: Exit