DFI EL331-RM - Manual (Page 58)

58
3
BIOS Setup
IDE Configuration
This section is used to configure the IDE drives.
Disabled
Compatible
Enhanced
BIOS SETUP UTILITY
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
IDE Configuration
Mirrored IDER Configuration
SATA#1 Configuration
Configure SATA#1 as
SATA#2 Configuration

Primary IDE Master

Primary IDE Slave

Secondary IDE Master

Secondary IDE Slave

Third IDE Master

Fourth IDE Master

Fifth IDE Master

Fifth IDE Slave

Sixth IDE Master

Sixth IDE Slave
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
Advanced
[Disabled]
[Compatible]
[IDE]
[Enhanced]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
[Disabled]
[35]
[Host & Device]
Mirrored IDER Configuration
Enables or disables the IDER feature.
SATA#1 Configuration / SATA#2 Configuration
These fields are used to configure the IDE device mode.
SATA#1 Configuration
The options are Disabled, Compatible and Enhanced.
SATA#2 Configuration
The options are Disabled and Enhanced.
Compatible
Legacy IDE channels will appear allowing you to configure the devices.
Enhanced
”Configure SATA as” will appear allowing you to configure the devices.

