DFI EL331-RM - Manual (Page 46)

46
2
Hardware Installation
Parallel
Chassis Instrusion Connector
The board supports the chassis intrusion detection function. Connect the chassis
intrusion sensor cable from the chassis to this connector.
Hardware Monitor for Windows
Install the “Hardware Monitor for Windows” utility. By default, the chassis intru-
sion detection function is enabled. When enabled, a warning message will appear
when the chassis is open. The utility can also be configured so that a beeping
alarm will sound when the chassis is open. Refer to the “Hardware Monitor for
Windows” section in chapter 4 for more information.
Chassis
signal
Ground
2 1