DFI CP337-NRM - Manual (Page 50)

50
2
Hardware Installation
1
Connect a 24-pin ATX main power connector from the power supply unit to the
24-pin power connector. The connector from the power supply unit is designed to
fit the 24-pin connector in only one orientation. Make sure to find the proper ori-
entation before plugging the connector.
The system board requires a minimum of 120 Watt power supply to operate. We
recommend that you use a power supply that complies with the ATX12V Power
Supply Design Guide Version 1.1.
Important
The system board consumes a minimal amount of power. Due to its low
power consumption, you only need a 120W to 150W power supply. Every
power supply has its minimum load of power. If you use a greater than
150W power supply, the power consumed by the system board may not
attain its minimum load causing instability to the entire system.
Power Connector
24
12
13
1
+3.3VDC -12VDC GND PS_ON# GND GND GND NC +5VDC +5VDC +5VDC GND
+3.3VDC +3.3VDC
GND
+5VDC
GND
+5VDC
GND
PWR_OK
+5VSB
+12VDC +12VDC +3.3VDC