DFI HU171 - Manual (Page 43)

www.dfi .com
43
Chapter 3 BIOS Setup
Chapter 3
Power Failure Control
This section configures the status when the power failure occurs.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Power Failure Control
Power-Loss State
Advanced
[Always on]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Control the status when
power loss occurs
Power-Loss State
Controls the status when the power loss occurs.
Always Off
When power returns after an AC power failure, the system’s power is off. You must
press the Power button to power-on the system.
Always On
When power returns after an AC power failure, the system will automatically power-on.
Keep Last State
When power returns after an AC power failure, the system will return to the state
where you left off before power failure occurs. If the system’s power is off when AC
power failure occurs, it will remain off when power returns. If the system’s power is on
when AC power failure occurs, the system will power-on when power returns.
WatchDog Configuration
This section sets the system watchdog parameters.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
WatchDog Parameters
WatchDog Count Mode
WatchDog TimeOut Value
Advanced
[Second]
0
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
WatchDog Count Mode
Selection
WatchDog Count Mode
Select the watchdog count mode: second or minute.
WatchDog TimeOut Value
Enter the watchdog timeout value. 0 means disabled.