Chapter 3, Chapter 3 bios setup – DFI HU171 User Manual
Page 40
www.dfi .com
40
Chapter 3 BIOS Setup
Chapter 3
PCH-FW Configuration
This section only displays the parameters of Management Engine Technology.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
ME FW Version
ME Firmware Mode
ME Firmware Type
ME Firmware SKU
PTT Capability/State
Firmware Update Confi guration
Advanced
9.5.30.1808
Normal Mode
Full Sku Firmware
5MB
1/0
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
F4: Save & Exit
ESC: Exit
Confi gure Management
Engine Technology
Parameters.
Enable or Disable Me FW
Image Re-Flash function
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Me FW Image Re-Flash
Advanced
[Disabled]
Firmware Update Configuration
This field is used to configure the parameters of Management Engine Technology.
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
F4: Save & Exit
ESC: Exit
Super IO Configuration
This section is used to configure the I/O functions supported by the onboard Super I/O chip.
Windows/Linux (DOS) for
COM port setting.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Super IO Confi guration
Super IO Chip
OS Select
Serial Port 1 Confi guration
Serial Port 2 Confi guration
Serial Port 3 Confi guration
Serial Port 4 Confi guration
Advanced
NCT6106D
[Windows]
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
F4: Save & Exit
ESC: Exit
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Serial Port 1 Confi guration
Serial Port
Device Settings
Change Settings
RS485 Auto Flow
Advanced
[Enabled]
IO=3F8h; IRQ=4;
[Auto]
[Disabled]
OS Select
Select the OS support, Windows or Linux/DOS, for COM ports settings.
Serial Port 1 Configuration to Serial Port 4 Configuration
Sets the parameters of serial port 1 (COM A) and serial port 4 (COM D).
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
F4: Save & Exit
ESC: Exit