Dish Network 6.4 - Manual (Page 20)

8
P ROGRAMMING THE R EMOTE TO C ONTROL A S ECOND
R ECEIVER IN AUX M ODE
If you have another DISH Network satellite receiver installed, you can
use this remote in AUX mode to control it along with your new
receiver. When you program the remote to control the other receiver,
the remote sends out IR and UHF (not UHF Pro) signals to the receiver.
You can program the remote to control any other DISH Network
satellite receiver, except for following:
• TV2 on Duo 322, DuoDVR 522 (also known as DISH Player-
DVR 522), DuoDVR 625 (also known as DISH Player-DVR
625), DISH Player-DVR 942, Duo ViP 222 (also known as ViP
222), DuoDVR ViP 622 DVR (also known as ViP 622 DVR) ,
and DuoDVR ViP 722 DVR (also known as ViP 722 DVR)
• DishPlayer 7100/7200
1 Turn on the other receiver. Use the SYSTEM INFO button on the
front panel to open the System Info screen.
3 Press the plus (+) side of
the VOLUME button.
3 Press the plus (+) side of
the VOLUME button.
4 Press the 0 number button. 4 Press the 0 number button.
5 Press the POUND (#)
button.
5 Press the POUND (#)
button.
The AUX mode button
flashes three times. The TV mode button
flashes three times.
M AKE SURE THE REMOTE
CONTROLS THE AMPLIFIER ’ S
VOLUME :
M AKE SURE THE REMOTE
CONTROLS THE TV’ S VOLUME :
6 Press the SAT mode
button.
6 Press the SAT mode
button.
7 Press the plus (+) and
minus (-) sides of the
VOLUME button.
7 Press the plus (+) and
minus (-) sides of the
VOLUME button.
8 The equipment’s volume
changes and the AUX mode
button lights instead of the
TV mode button.
8 The TV’s volume changes
and the TV mode button
lights instead of the AUX
mode button.
Control Amplifier Volume Control TV Volume