DFI BT160 - Manual (Page 36)

www.dfi .com
36
Chapter 3 BIOS Setup
Chapter 3
Serial Port
Enable or disable the serial COM port.
Change Settings
Select the IO/IRQ settings for the super I/O device.
RS485 Auto Flow (COM 4 only)
Set the RS485 auto flow of the serial COM port.
Advanced Sleep State Control
Advanced sleep state control (ASSC) function is used to control the system power.
Enable or Disable (ASSC)
Function. SLP_S5# state
enter Deep S5 state.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Advanced Sleep State Control
DEEP S5 Enable
Advanced
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
When the Advanced Sleep State Control (ASSC) function is set to Enabled, it will
display the following information:
DEEP S5 Enable
Enable or disable the Advanced Sleep State Control (ASSC) function.
Enable or Disable (ASSC)
Function. SLP_S5# state
enter Deep S5 state.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Advanced Sleep State Control
DEEP S5 Enable
PSOUT Delay Time
PSOUT Pulse Width
Deep Sleep Delay Time
Advanced
[Enabled]
32
4
5
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
PSOUT Delay Time
Enter the value to set the delay time which is (setting value)*16ms. For example, the
maximum delay time = (3F)hex*16ms=1008ms. (Default: 512ms)
PSOUT Pulse Width
Enter the value to set the pulse width which is (setting value)*32ms. For example, the
maximum pulse width = (F)hex*32ms=480ms. (Default: 128ms)
Deep Sleep Delay Time
IO will wait for a delay time before entering into the deep sleep state. For example,
the maximum delay time = 127 second. (Default: 5 sec)