DFI QB702-B - Manual (Page 19)

www.dfi .com Chapter 2 Hardware Installation
19
Chapter 2
Installing QB702-B Series onto a Carrier Board
1. The photo below shows the locations of the mounting holes and the bolts already fixed in
place.
2. Grasping QB702-B Series by its edges, insert it into the carrier board, and you will hear a
distinctive¨click¨ indicating QB702-B Series is correctly locked into position.
Mounting hole
QB702-B Series
Carrier board
Standoff Bolts
3. Press down QB702-B Series and put on the heat sink on top of QB702-B Series with its
mounting holes and bolts aligned on the carrier board. Use the mounting screw to fix
QB702-B Series and heat sink on place.
Long screws
Short screws
Important:
The carrier board used in this section is for reference purpose only and may not
resemble your carrier board. These illustrations are mainly to guide you on how to
install QB702-B Series onto the carrier board of your choice.