DFI EC300 Series - Manual (Page 33)

3
33
Installing Devices
Chapter 3 - Installing Devices
Removing the Chassis Cover
1. Make sure the system and all other peripheral devices connected to it has
been powered-off.
2. Disconnect all power cords and cables.
3. The 6 mounting screws on the front and rear of the system are used to se-
cure the cover to the chassis. Remove these screws and then put them in a
safe place for later use.
Mounting
screw
EC300/310/320/321
4. After removing the mounting screws, lift the cover up.
Lift the Cover Upward