DFI ES520-CD Manual - Manual (Page 15)

www.dfi .com
15
Chapter 4 Jumper Settings
Chapter 4
Power-on Select
Note:
The default setting is eDP.
1. 1366x768: N2000 series processor supports eDP only.
2. 1600x1200: N2000 series processor supports DP only.
3. 1920x1080: D2000 series processor supports eDP only.
4. 1920x1200: D2000 series processor supports DP only.
1-2 On:
Power-on via power button
(default)
2-3 On:
Auto power-on
JP5
3 1 2
JP5 is used to select the method of powering on the system. If you want the system to
power-on whenever AC power comes in, set JP5 pins 2 and 3 to On. If you want to use the
power button, set pins 1 and 2 to On.
When using the JP5 “Power On” feature to power the system back on after a power failure
occurs, the system may not power on if the power lost is resumed within 5 seconds (power
flicker).
Note:
In order to ensure that power is resumed after a power failure that re covers within a
5 second period, JP5 must be set to pins 2-3 and the “AC Power Lose” in CMOS is set
to “On”.
3 1 2