DFI ES520-CD Manual - Manual (Page 14)

www.dfi .com
14
Chapter 4 Jumper Settings
Chapter 4
Panel Power Select LVDS Panel Select
JP2
JP2 is used to select the power supplied to the LCD panel.
1-2 On: +12V 3-4 On: +5V 5-6 On: +3.3V
(default)
1 3 5
2 4 6 2 4 6
1 3 5
2 4 6
1 3 5
Important:
Before powering-on the system, make sure JP2’s setting matches the LCD panel’s
specification. Selecting the incorrect voltage will seriously damage the LCD panel.
SW2
SW2 is used to select the resolution of LVDS panel on the system.
LVDS Panel Select Channel SW2
800x600 6/18 bit Single 1-4 On
1024x768 6/18 bit Single 2-4 On, 1 Off
1024x768 8/24 bit Single 1,3,4 On, 2 Off
1280x768 6/18 bit Single 3-4 On, 1-2 Off
1280x800 6/18 bit Single 1,2,4 On, 3 Off
1280x960 6/18 bit Single 2,4 On, 1,3 Off
1280x1024 8/24 bit Dual 1,4 On, 2,3 Off
1366x768 6/18 bit Single 4 On, 1-3 Off
1366x768 8/24 bit Single 1-3 On, 4 Off
1440x900 8/24 bit Dual 2-3 On, 1,4 Off
1400x1050 8/24 bit Dual 1,3 On, 2,4 Off
1600x900 8/24 bit Dual 3 On, 1,2,4 Off
1680x1050 8/24 bit Dual 1-2 On, 3-4 Off
1600x1200 8/24 bit Dual 2 On, 1,3,4 Off
1920x1080 8/24 bit Dual 1 On, 2-4 Off
1920x1200 8/24 bit Dual 1-4 Off