Dacor IF36BNDFSF - Manual (Page 4)

IF36 Panel Overlay Installation
Page 4
h
andle
d
IMenSIonS and
I
nStallatIon
Before installing a custom panel assembly, you must install
•
the custom handle hardware.
Dacor recommends handles with larger D-style pulls. If using
•
screws with thick heads, they must be countersunk into the
panel before installing the handles.
Any handle designed for use with an appliance should
•
produce satisfactory results.
Mounting screw length varies with the total thickness of the
•
panels.
On two door models: The top handle is mounted on the left or
•
right side of the door depending on door swing.
IMPORTANT: Dacor advises not using single pull knobs.
20" (508mm)
20” Typical
(50.8 cm)
36” Max.
(91.4 cm)
Example of
Door Handle
Detail “C”
Side View - Handle Installation on
Top Doors on three Door Model
Detail “D”
Side View - Handle Installation on
All Other Doors
Double sided
tape between
doors and
panels
Apply two strips of double sided
thin tape between door front and
panel back on each side of door
handle
Counter Sink
Screw
Handle
Door Panel
Assembly
Door
Door
Trim Frame
Surrounding Door
Door Panel
Assembly
Handle
Counter Sink
Screw
Three Door Model Two Door Model
Detail “C”
Detail “D”
Detail “D”
Detail “D”