Datatek IPv6 Transformer User Manual - Manual (Page 29)

S E C T I O N 6 L O G I C A L S E T U P
29
You aren’t required to supply an IPv4 or IPv6 address for the network side interface. If you don’t
supply an IPv4 address, you won’t be able to access the webGUI from the network-side interface
using IPv4. If you don’t supply an IPv6 address, you may still be able to access the webGUI
using IPv6. This is because the network-side interface is automatically assigned an IPv6 link-local
address.
Once you make changes to the host or network-side IP addresses, you must reboot the
Transformer before the changes will take effect. To do this, from the Console Main Menu, select
item 4, Reboot system.
6.2 Reset webGUI password
This selection resets the webGUI password to the factory default. To do this, from the Console
Main Menu, select item 2 – Reset webGUI.
6.3 Reset to factory defaults
This selection resets all configured values to the factory defaults, including those that you have
setup using the webGUI. Use it when you want to make a fresh start, like when you’re moving a
Transformer from one legacy device to another. To do this, from the Console Main Menu, select
item 3 – Reset to factory defaults
Setting the unit back to the factory defaults will remove the registration key and a new one will need to be
obtained from Datatek
6.4 Reboot system
This selection reboots the Transformer. To do this, from the Console Main Menu,
select item 4 – Reboot system.
6.5 Ping host
This selection allows you to enter either a hostname or IP address of a target machine that you
wish to ping. To do this, from the Console Main Menu, select item 5 – Ping host. The IP address
can be either an IPv4 or IPv6 address. However, Ping6 directed to the legacy host will not work.