Datatek IPv6 Transformer User Manual - Manual (Page 24)

S E C T I O N 3 P H Y S I C A L S E T U P
24
After booting, you will be greeted with the login prompt, as shown below. You can enter any
character at this time, which will bring you to the Console Main Menu, as shown below.
However, if the Console Main Menu does not appear on the console within about 3 minutes of
booting, contact support. More information on the Console Main Menu configuration selections
is discussed in the next section.
login: test
Datatek Transformer Console
**********************
1) Set up IPv4 and IPv6 interfaces
2) Reset webGUI password
3) Reset to factory defaults
4) Reboot system
5) Ping host
6) Change password
7) Logoff
Enter a number:
When the Transformer is shipped from the factory, the host-side IPv4 address is set to 172.31.0.1.
The network-side port is not assigned an IPv4 address. However, network-side port has an IPv6
link-local address and it will participate in IPv6 Stateless Address Autoconfiguration.