Daktronics Gen V Radio - Manual (Page 12)

6 Setting Radio Channels
Multiple controller systems typically use Broadcast 1 and Channel 1 for the first controller
and Channels 2-8 for all remaining controllers. All jumpers in the radio receivers must be set
to Broadcast 1 (BCAST 1).
Display Action
The LCD will toggle between
these 2 screens.
The LCD shows the current radio settings along with a prompt
to accept or modify these values.
If the radio settings are correct press .
If these values are incorrect press , and the LCD at
bottom left is shown, allowing edit of the channel or broadcast
group setting.
Broadcast Group Setting
1 Use this setting for all multiple controllers with single
broadcast group setups. Use the number keys to edit
this value and press to accept. The asterisk
will move to the channel setting.
Channel Setting
1-8 Channels 1-8 may be used with broadcast channel 1.
Edit the channel number to the desired value and press
to accept. The channel switch on the
receiver must match this value and only the Broadcast
1 (BCAST1) jumper must be set.
ENTER TO ACCEPT
CLEAR TO MODI FY
RADI O SETTI NGS
BCAST X CHAN YY
BCAST GROUP 1*
RADI O CHAN 01