Daktronics Sportsound Rack SSR-100 Operation Manual - Manual (Page 16)

10 Setup & Operation
3.3
Announcer’s Interface Operation
Refer to Figure 16 for locations of the following controls and jacks.
1. XLR input jack - connect gooseneck or headset microphone
2. HEADPHONE VOLUME – Turn this knob clockwise to increase and counter-
clockwise to decrease headphone volume.
3. MIC LIVE – This LED indicator lights up when the microphone is live.
4. CONTINUOUS – Press this button once to activate the microphone and turn on the
MIC LIVE indicator. Press this button again to deactivate the microphone and turn
off the MIC LIVE indicator.
5. MOMENTARY – Hold down this button to activate the microphone. Release this
button to deactivate the microphone. The MIC LIVE indicator will remain on as long
as the button is pressed.
6. HEADPHONES – ¼" jack for headphones (or single-muff headset)
7. MIC 1 – XLR output jack to audio mixer
8. AUX 1 – XLR input jack from audio mixer
9. POWER INPUT – plug in provided 24 VDC wallpack transformer
10. MIC ONLY/MIXED AUDIO – Located on the bottom of the console, this switch
determines whether the announcer can hear only their microphone or all audio
sources through the headphones. Leave this set to MIXED AUDIO.