Daktronics MF-1000/1001/1002/1003/1004 - Manual (Page 14)

2-2 Mechanical Installation
MF-1000 Series Installation
Reference Drawings:
MF-1000 Series Display Installation............................ Drawing A-222256
Shop Drawings ................................................................ See Appendix A
The MF Series cabinets contain two horizontal extrusions, two end plates, a
polycarbonate face, and a backsheet. The LEDs are all contained in one circuit board
that slides into grooves in the extrusions. Another circuit board attached to the LED
board has the transformers mounted to it.
Installation of the MF Series displays consists of the following steps:
1. Remove the backsheet by first unscrewing the two #6 screws on the bottom of
the display and then sliding the backsheet down and away from the display.
2. Knock out one of the two access holes, as shown in Drawing A-222256, from
the inside of the backsheet to the outside. This hole will be used to route pigtail
wires to the driver circuit of the display.
3. Attach the backsheet to the wall where desired. Two keyholes in the backsheet
allow mounting to two #10 screws.