Daktronics VIP-4060 - Manual

VIP-4060 Quick Guide 1 of 6
DD1733958 Rev 04
08 December 2014
201 Daktronics Dr. P.O. Box 5128 Brookings, SD 57006
tel: 800-325-8766 fax: 605-697-4700
www.daktronics.com
The VIP-4060 is the interface that drives video to the display and meets operational needs such as dimming,
displaying test patterns, and adjusting gamma and color controls. This quick guide explains basic VIP-4060
connections and setup as shown in Figure 1.
Hardware Setup
Connecting VIP-4060 to LED Display
1. Locate fiber-optic Port A and Port B on the VIP-4060.
2. Insert duplex LC fiber-optic cables into their corresponding ports. The cables will
click into place when seated properly. Refer to Figure 2.
Note: Remove fiber dust covers from the cables prior to inserting into ports.
Connecting Video Source – SDI or V-Max ™ Signal
1. Connect the BNC cable to the top SDI/V-Max ™ input. Refer to Figure 3.
2. Rotate the connector 1 /
4
turn clockwise to lock.
3. Ensure that a 75 ohm terminator is connected to the bottom BNC.
Note: The bottom BNC does not function as a loop out.
Connecting Video Source – DVI
1. Insert the male plug into the female jack.
2. Turn the screws on the male plug clockwise to lock. Refer to Figure 4.
Video Source
Computer Daktronics LED Video Display
VIP
Figure 1: VIP-4060 Connections
Figure 2: Fiber-Optic
Ports
Figure 3: SDI/V-Max ™ 4
Input
Figure 4: DVI Input