Daktronics TN-2501 Tuff Sport Indoor LED Tennis Scoreboard - Manual (Page 16)

10 Electrical Installation
6. Install the 1 /
4
" phone plug (part # 0L-40683) to the display end of the cable.
Be sure to connect the cable shielding only in the J-box on this end.
Note: DO NOT connect cable shielding at the J-box near the control console.
7. Route the 1 /
4
" phone plug from the J-box near the display to the scoreboard.
8. Insert the plug into the J31 SIGNAL IN jack on the first scoreboard section, and
connect signal cables between each section as described above.
Wireless Connection to Scoreboard
For multi-court scoreboards with TNMCs and a wireless signal to the scoreboard(s), refer to
the instructions below and Drawing B-1077063 in Appendix A.
1. Plug in the wireless base station (part # 0A-1110-0037) within 12' (3.6 m) of the
DakTennis computer. Ensure the wireless base station is set to Function “5”.
2. Connect the 9-pin serial cable (part # W-1267) between the RS232 jack of the wireless
base station and an available COM port on the DakTennis computer.
Note: If the DakTennis computer only has only one or no COM port, it will be
necessary to use USB-to-Serial converters (not provided by Daktronics).
3. Connect the 9-pin to 25-pin serial cable (part # 0A-1374-0106) between the DakTennis
computer and the J6 I/O PORT jack of a radio-equipped All Sport 5000 console.
4. Ensure the All Sport console and the primary scoreboard as well as any auxiliary
single-court scoreboards are set to the same radio Broadcast and Channel numbers.
The console must also be set to Code 5900.
3.5 All Sport CG Setup
An All Sport CG allows live game information to be overlaid onto a video signal. This setup
requires an All Sport CG unit and video camera for each court, a signal distribution amplifier,
and associated wiring. Refer to Drawing B-231298 (wired) or Drawing B-1077063 (radio) for
more information about typical setups.