Daktronics TN-2501 Tuff Sport Indoor LED Tennis Scoreboard - Manual (Page 14)

8 Electrical Installation
Radio Settings
Tennis scoreboards display radio settings during the POST in certain digits depending on the
scoreboard model and controller type, as shown in Figure 10.
 With an RC-100 base station installed, “CXX” will display, where the XX is a channel
from 01-15. The default is channel 01. Refer to Drawing A-252412 in Appendix B.
 If an All Sport radio receiver is installed (for use with TNMCs), “bXCY” will display,
where X is the broadcast setting and Y is the channel setting. The default is b1C1.
Refer to Drawing A-177098 in Appendix B.
These values must match the settings in the control console (refer to the appropriate control
console manual listed in Section 1.1).
Note: For scoreboards that only display team score, the radio settings will not be visible.
3.3 Single-Court Scoreboard Signal Connection
For single-court scoreboards using a wired All Sport 5000 setup, signal installation requires
routing control cable from the scoreboard control console to a signal junction box (J-box) near the
display. Refer to Drawings A-28124 and A-177098 in Appendix B for wired signal connection.
1. At a minimum, use a paired, 22 AWG shielded cable (part # W-1077) and connect the
cable to a 1 /
4
" J-box at the control console end.
2. Route the cable from the J-box on the control console end to a J-box near the display.
3. Install the
1 /
4
" phone plug (part # 0L-40683) to the display end of the cable. Be sure to
connect the cable shielding only in the J-box on this end.
Note: DO NOT connect cable shielding at the J-box near the control console.
4. Insert the plug into the J31 – SIGNAL IN jack located on the top of the scoreboard.
5. Connect a signal cable from the J-box to the J1, J2, or J3 jack on the back of the All
Sport 5000 console.
Figure 10: Radio Settings